You use kolimer 7.2 loader? Use loader but with eng 18.9.0. ![]() Than bootloader still Life then you can try flashing using VAGCOM_EEWriteLang And press READ (PRESS WITH CONNECTED PLUG TO 12V) if show you not reapond than you brick atmega162. ![]() And go to option and do TEST, If CABLE and all is ok Activation should back to Activate status. I'd flash the cable using VAGCOM_EEWriteLang (without changing anything on the cable)īut still getting that Not ready CAN status when doing test.Ĭan anyone help ?You use kolimer 7.2 loader? Use loader but with eng 18.9.0. Since then, when i do my test I get the CAN Not ready result. Was able to use it for a few minutes and after that got a message saying to get a valid license/interface (can't remember) ![]() Just got this little cable for my Audi s3 2017 (it's actually written VAG189 on mine)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |